Subscribe

RSS Feed (xml)

Powered By

Design:
dollresed

Powered by Blogger

iklan

15/11/10

AdSense Tip #6: Carefully craft blog or forum pages

AdSense Tip #6: Carefully craft blog or forum pages

My series of AdSense tips continues with a tip closely related to AdSense Tip #1: Don't put ads on empty pages. This tip is AdSense Tip #6: Carefully craft blog or forum pages.
AdSense publishers often complain that the ads that get shown on blog and forum pages are not really that relevant to the topics being discussed. This is because the Mediapartners crawler — the crawler that fetches and analyzes pages that display AdSense ads — visits pages at unpredictable intervals. The first impression you make to that crawler, as discussed in Tip #1, is therefore extremely important. The first time the crawler visits your forum/blog there better be some relevant content on display there.
There's another problem with many blogs and forums: the keyword density is skewed by all the links and extra “fluff” found on the page. For example, many blogs have multiple feed links listed on the page. These are often images. If those images all have alt attributes that say something like “RSS feed for GoofySite.com, a blog about Goofy” then “blog”, “feed” and “Goofy” will have higher densities than you might expect, especially if (in this case) “Goofy” and “GoofySite.com” show up in other places on the page (links to the home page, links to other pages on the site, alt attributes for images, and so on). You shouldn't be surprised if all the ads you see for that blog end up being related to blogging and/or Goofy, and not necessarily the specific topics being discussed.
There's no predicting when the Mediapartners crawler shows up, so it's hard to tune things for it. You can control when the first crawl occurs, though, so spend some time tuning that first crawl by making sure the blog/forum is displaying the right kind of content. Use a keyword density checker on the page before you place ads on it to make sure things are OK, then activate AdSense for that page.
Note that you'll have better control over permalink pages and thread-specific pages, provided again that you don't have too much fluff on those pages, either.
If things are really bad, rename the page and place a redirect in the old page's place. I had to do this recently with my Vioxx page. In Make Easy Money with Google I point readers to the www.memwg.com/vioxx-withdrawal address for additional information about Vioxx. But the ads that were showing weren't well-targeted, because in my hurry to get the page up (there's another AdSense tip — take your time!) I had neglected to check the keyword density. But when I did, after the fact, it's because that “fluff” I mentioned above was overpowering the Vioxx-related keywords. So after I fixed the page I renamed it to www.memwg.com/vioxx-recall and changed the original to redirect to the new one. When I activated the ads on the new page, the crawler was able to correctly figure out what the keywords were and now the ads that are shown there are highly relevant.
The fix-and-rename technique works well, but it's not always possible to do it, in which case you just have to wait for the Mediapartner crawler to revisit your site. Perhaps Google's new sitemap feature will help in this regard, but I haven't done any experiments yet to know if that's true or not.

0 komentar:

Posting Komentar